NiosII SBT4E post-processor action

Question

Hi,

I need someone's help in figguring out how to automatically call a script after each project build. I was not able to find out anywhere in the menus the Eclipse - typical pre-processor step or post-processor step.

What I want to do is call a Perl script once the .elf file is generated.

Any help appreciated. Thank you!

altera_forum · Answer

I was able to do it only by using the "advanced" section of the corresponding bsp. (as described here http://www.alterawiki.com/wiki/file:make_tricks_v1.0.doc)

But how do I do it in the settings of the application only?

I need this because in my configuration I share one BSP with multiple applications running in the same hardware.

Thanks!

Forum Discussion

NiosII SBT4E post-processor action

1 Reply

Recent Discussions

Questa unable to checkout a viewer license

Timing analysis - long combinational path

Error(23098) when using IPM_IOPLL on Agliex 7

Quartus Prim Pro: "Fatal Error: Segment Violation, Access Violation"

Crash at elaboration