Forum Discussion

Elit's avatar
Elit
Icon for Occasional Contributor rankOccasional Contributor
5 years ago

Modelsim Intel FPGA Edition 2020.3 Pro and 2020.1 Standard license problem

Hi I'm trying to run the Verilog HDL Testbench for a Single /Two Avalon-MM Master and Slave Pair. With Modelsim Intel FPGA Edition 2019.4 Pro everything is good, but with 2020.3 Pro and 2020.1 St...
AR_A_Intel's avatar
AR_A_Intel
Icon for Super Contributor rankSuper Contributor
5 years ago

Hi

Thanks for update. This most probably look like bug issue in Quartus. May I know, is the Q pro 19.4 and Q pro 20.3 install in same PC? If possible, could you uninstall Q pro19.4 and tested using Quartus Pro 20.3 only or uninstall both Quartus and install back Q Pro 20.3 and retest using the new license that we provide. See how thing goes.


Elit's avatar
Elit
Icon for Occasional Contributor rankOccasional Contributor
5 years ago

Hi

I uninstalled all versions of Quarus on my computer and only installed 20.3 Pro.

Unfortunately nothing has changed. Modelsim Intel FPGA edition 20.3 Pro messages:

** License Issue: License request for alteramtivlog feature failed
** License Issue: No such feature exists. (C:\FLEXLM\license.dat)
** License Issue: No such feature exists. (C:\FLEXLM\license.dat)
** License Issue: No such feature exists. (C:\flexlm\license.dat)
** Error: Failure to obtain a Verilog simulation license. Unable to checkout any of these license features: 'alteramtivsim' or 'alteramtivlog'.
Error loading design

Quatus license setup

Attached license.dat file

Thanks

Elit