Forum Discussion
New ContributorMax10 ADC simulation in QuestaSim fails to simulate output
Hi @twister1398
This is normal behavior, if you compile the fiftyfivenm_atoms_ncrypt.v standalone, you can see there are modules listed in the compiled library.
Regarding to ready signal (modular_adc_0_command_ready) never goes high, I would suggest to review your design and testbench.
You may checkout the User Guide below for further information:
Best Regards,
Richard Tan
p/s: If any answer from the community or Intel support are helpful, please feel free to give Kudos.
Super ContributorHi @twister1398
This is normal behavior, if you compile the fiftyfivenm_atoms_ncrypt.v standalone, you can see there are modules listed in the compiled library.
Regarding to ready signal (modular_adc_0_command_ready) never goes high, I would suggest to review your design and testbench.
You may checkout the User Guide below for further information:
Best Regards,
Richard Tan
p/s: If any answer from the community or Intel support are helpful, please feel free to give Kudos.
Super ContributorHi @twister1398
Thank you for the best answer confirmation. I’m glad that your question has been addressed. With that, I will now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.
Best Regards,
Richard Tan
p/s: If any answer from the community or Intel support are helpful, please feel free to give Kudos.
