Forum Discussion
VRb
New Contributor
New ContributorIn Signal Tap, I have set trigger conditions on more than one signal(tapping on AXI signals). I have set to Basic AND condition on 2 signals while rest of them are don't care . Can I expect a capture correctly?
I have set Allow trigger condition changes only which will allow me to change trigger condition changes after compilation. Since I want to change the trigger condition dynamically, I am confused wit...
AnandRaj_S_Intel
Regular Contributor
Regular ContributorHi,
Refer below link
https://www.youtube.com/watch?v=vhkzxCEXuaA
https://www.youtube.com/watch?v=xRJRC1B_oDw
Let me know if this has helped resolve the issue you are facing or if you need any further assistance.
Best Regards,
Anand Raj Shankar
(This message was posted on behalf of Intel Corporation)
