Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

How to print signal tap graphics?

Moin, I'm using QII6.1. Attached signal tap to view some signals of my design; seems to work ok. Now i want to print the signal forms. When i do so, i only get the possibility to print out 6...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

I have another wrinkle to add to this older thread. What about exporting the signal & trigger name set-ups. Anyone know if just that information can be exported then imported or brought forward to a new design?

I do not want the data (which is what this thread covered), the old data served its purpose to help debug the design now the design has changed and been back through place & route.

All of the signals & signal names connected to the STP module are the same but since I have an updated sof the older STP file causes the interface to want me to recompile. That wouldn't be a problem to do, I just do not want to re-enter all of the signals. Anyone know how to get around this?

Thanks in advance,

Br