Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

Cyclone III LS doesn't boot w/o ByteBlaster

I am using a Cyclone III LS, using JTAG to program during development, and a Serial Configuration Device to load the FPGA once that is finished. I programmed the .jic file into the SCD in order...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

Hi,

I had a problem quite similar to your one and I found that it was a problem of console that was probably full of debug messages... You could try removing debug messages (at least only someone) or disabling default stdout to jtag (within syslib settings for old IDE or wihing BSP editor).

Ciao