Forum Discussion
nasalmirror
New Contributor
New ContributorCyclone 10 fails to program jic on MT25QU128 memory
As the suject states, my cyclone 10 10CL010Z256IG fails miserably to program jic on the attached memory, which is a MT25QU128. The hardware is all configured properly, with all pins connected how the...
YuanLi_S_Intel
Regular Contributor
Regular ContributorYou may refer to guide below to change TCK frequency on USB Blaster, i would suggest to try with 16M / 6MHz.
Meanwhile, check you MSEL and see if it is set to active serial mode or not.
nasalmirrorNew Contributor
New ContributorI already tried doing that, but my USB BLASTER is not the Second version, and the JTAG jtagconfig --setparam <cable number> JtagClock <frequency> doesn't work. It says that JtagClock is an invalid parameter.
I would also like to know how to adjust the CS timings in a custom memory model (from quartus programming file converter), and then pass it to the jic file.
