counting output pulse(project)

Hi Sam,

Please use this as reference.

module pulse_atN(Clk, Reset, Pulse, N);

parameter WIDTH = 10;

input Clk, Reset;

input [WIDTH-1:0] N;

reg [WIDTH-1:0] Nlast;

reg [WIDTH-1:0] Count;

output Pulse;

assign Pulse = (Count == N-1) && (N != 0);

always @ (posedge Clk, posedge Reset)

begin : PULSE_GENERATOR

if(Reset)

Count <= 0;

else

begin

// nonblocking so check occurs with old Nlast

Nlast <= N;

if(Nlast != N)

Count <= 0;

else if(Count == N-1)

begin

Count <= 0;

Pulse = 1;

end

else

begin

Count <= Count + 1;

Pulse = 0;

end

end

end

endmodule