Can't install Quartus web 13.0 on CentOS 6.3

search for the symptoms you described on the web. I had same the problem with Fedora 17. I had to chmod +x several files before it worked.

Let me know if you get it installed. I cannot get Qsys to run on Fedora, so I may move to Centos or Ubuntu

Well, I did look for anything remotely similar, but came up empty.

I did check the permission bits on the files (setup.sh, QuartusSetupWeb-13.0.0.156.run), and they have the correct read and executable bits set.

Thanks for responding, though.

Quick Note:

I ran the "file" command on the QuartusSetupWeb-13.0.0.156.run executable and found that it was a 32-bit executable. That may be problematic for a 64-bit machine.

So, the combined file, Quartus-web-13.0.0.156-linux.tar, may not be a good idea after all (although there is no guarantee that the individual files will fare any better).

A bit disillusioned.

do you have any update?

can you post what you are getting when you try to run the install?

Hi ppitou,

I'm getting nothing when I execute the install script - as in: no output, no error messages, etc. It just comes right back to the shell prompt. That's all there is.

The only clue that I have is that the executable is apparently 32-bit, and I am using 64-bit CentOS - theoretically, I think that you can still run a 32-bit executable, but it should spit out some sort of error message if it doesn't have the necessary support libs.

Don't know what I else I can tell you - it just plain doesn't work. And I get the impression that perhaps it isn't a pressing issue for Altera. Sorry.

Thanks for following up, though.

Cheers,

g.

Hi gwicks,

I ran into the same issue when I was trying to install Quartus 13.0 on my laptop running Centos 6.4 (64-bits).

After installing the compat--libstdc++-33.i686 package I was able to run the setup.

All the required packages are listed on page 1-4 of the Quartus installation manual.

I hope this helps.

Best Regards,

Marco