Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
10 years ago

"cannot place 2 nodes into a single alm" error message while doing signalProbe

Hi All, I am getting this "cannot place 2 nodes into a single alm" error message while doing signalProbe. This issue comes to me suddenly, and I have always been able to do signalProbe without ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
7 years ago

I face the same issue.

It is design dependant unfortunately.

I'm trying other synthesis/fitter options to see how I get signal probe working again.

If you found anything, let me know.

Altera was not able to reproduce at their side with simple test case.

Note: I must stick to version 13.1 as further versions of Quartus does not support the stratix III FPGA anymore.