Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Arria 10 GX OpenCL setup question

I have an Arria 10 GX development kit that I am trying to set up for OpenCL. Thus far I have been able to program the board with the initial configuration for the MAX V and the Arria 10, but I have b...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

May not be relevant,

the problem I had with this step is that the guide failed to mention you have to set the jtag speed to 6M again after the reboot.