Forum Discussion

HSuh01's avatar
HSuh01
Icon for New Contributor rankNew Contributor
3 years ago

Analysis & Synthesis on Quartus 19.4 fails without any error.

Hi,

I am working on the Straix MX 10 which comes with HBM on the board.

While I am working on the synthesis of my design, I got stuck on Analysis & Synthesis stage.

I shows "x" mark on the compilation flow window, but the transcript or message window show no error.

I think it's a problem of quartus' verbosity setting what should I change to increase the tools verbosity of the transcript window?

Thank you for any input.

Best,

Hsuh

3 Replies

  • ShengN_altera's avatar
    ShengN_altera
    Icon for Super Contributor rankSuper Contributor
    3 years ago

    Hi,

    May I know your OS operating system?

    Do you have enough memory ram?

    Thanks,

    Best Regards,

    Sheng

  • ShengN_altera's avatar
    ShengN_altera
    Icon for Super Contributor rankSuper Contributor
    3 years ago

    Since there are no further feedback for this thread, I shall set this thread to close pending. If you still need further assistance, you are welcome reopen this thread within 20days or open a new thread, some one will be right with you.