Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Altera cyclone 5 is not booting from spi

​I created one uart program in quatux 2,i added uart in qsys,on chip memor and serial flash loader .i compiled it in quarux 2 .it succesfully compiled.when i opening this project in nios and cr...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

--- Quote Start ---

Hi,

1.Do you mean flash controller?

2.In NiosII, check if "reset vector memory" points to a memory module and not e.g. jtag etc.

same with "exception vector memory"

Best Regards,

Anand Raj Shankar

(This message was posted on behalf of Intel Corporation)

--- Quote End ---

hii

I again compiled program ,in "reset vector memory "i selected serial memory controller and in "exception vector memory" i selected onchip rom.than in eclipse previous error not coming.

but when i converting .sof file to jic than after selecting .hex data and START mode following error coming.

" hexadecimal file data overlaps ram data."