Forum Discussion

CHatz's avatar
CHatz
Icon for New Contributor rankNew Contributor
5 years ago

14566 The Fitter cannot place 5 periphery component(s) due to conflicts with existing constraints

In Platform Designer, for the Arria 10 Hard Processor System, in Tab "IP Selection", I have set GPIO = 5. In Tab "Advanced Pin Placement", for HPS Shared I/Os, I have the following selections: Q1...
SyafieqS's avatar
SyafieqS
Icon for Super Contributor rankSuper Contributor
5 years ago

Hi Costas,


Based off the error messages the reason the pin placement fails is because the pin is already used by a different port. Can you try to remove the pin assignment perhaps let the Quartus auto assign the pin location?