Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

13410 pin stuck at GND, but simulation ok

Hi there, I'm getting the compile error "13410 Pin led_col_ctrl[n] is stuck at GND" on 15 pins of a 36 pin output vector. When I simulate the design in modelsim these same pins work as expected (i.e...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

Strange - I tried both downloading the archived project to a fresh folder and also doing Project->Clean on the original project and in both cases I got the same result again....

I just noticed that you are using Quartus II 15.0.2, while I'm using Quartus Prime 17.0.0 - could that be the difference? I assumed it was something stupid I was doing.