Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

pausing target processor: not responding

hi all, i hav build a system in sopc builder using nios ii cpu, jtag_uart, esps_flash_controller, ddr_high_performance_memory_controller, tse_mac, sgdma_rx, sgdma_tx, flash_tristate_bridge, ext_f...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

hi,

thank you cris and kbs972 for ur replies.

i rebuilt my system, i removed ext_flash component and instead of ext_flash i set on_chip memory as reset vector of nios ii.

now pausing target processor problem doesn't exist.

but nothing is getting printed in the console

am getting the following messeges:

nios2_terminal: connected to H/W target using UART on cable

nios2_terminal: "USB-Blaster[ USB-0]",device 1,instance 0

nios2_terminal: (use the IDE stop button and Ctrl-C to terminate)

but hello from nios ii is not getting printed.

pls help me.

thank you.