Hello people.
I am not able to understand how I should proceed (if at all I am proceeding in the right direction here). I would be glad if someone could clarify a few sticking points I have:
- After analyzing many upon many threads, some related some not, I am hypothesizing that my non responsive processor could be mainly because I have not met timing requirements in my design. Am I correct on this one?
- The most troublesome warning for me was the one I showed above, which says that my node does not have an associated clock. After going through a couple of threads, I think that I should manually tell Quartus that that node is indeed being driven by an external clock. Is that correct? Or is it so that quartus has understood that it is so but the timing requirements have not been met (but how could that be possible since the oscillator core is not my component. Its an onboard component).
- Is there anything else besides the clocking issue that I should think about? I am not using any custom components.
I am keen to hear from you folks
Honored Contributor
