FPGA-to-HPS SDRAM Bridge in Bare-metal

Can you send me a basic baremetal example to read HPS SDRAM from FPGA like your VHDL state machine? I spent some weeks of my time and my project don't works. I read all the forum but I think the help of an example could help me now. Please!

--- Quote Start ---

FPGA-to-HPS SDRAM Bridge in Bare-metal

I am using DE1-SoC to start bare-metal programming for dual-core Cortex-A9 ARM hard processor, Cyclone V.

I'm trying to read data from SDRAM to FPGA using FPGA-to-HPS SDRAM Bridge.

I configured FPGA-to-HPS SDRAM interface in qsys to use avalon-MM Read only, 32 width.

I exported FPGA-to-HPS SDRAM Bridge avalon-MM Read only and write verilog state machine for reading

..

always @ (posedge DDR3_clk )

begin

if(sdramState == READ) begin

DDR3_read <=1'b1;

DDR3_write <=1'b0;

if(DDR3_waitrequest==1'b0 && DDR3_read==1'b1)begin

if(!wrfull_vga_fifo ) begin

if(sdram_rd_cnt == (0 + 110591) ) begin

sdram_rd_cnt <= 0;

end else begin

sdram_rd_cnt <= sdram_rd_cnt + 1'b1;

end

DDR3_address <= sdram_rd_cnt; //+ A_FRAME_SA;

data_to_vga <= DDR3_readdata[15:0];

wrreq_vga_fifo <= 1'b1;

end else begin

wrreq_vga_fifo <= 1'b0;

end

end else begin

wrreq_vga_fifo <= 1'b0;

end

end

end

And I build preloader using bsp-editor.exe and load it using Eclipes of DS-5.

When I traced FPGA-to-HPS SDRAM Bridge "avalon-MM Read only signals" on signalTab, The output was:

avalon_DDR3_waitrequest signal was always 1.

Then I added in main():

alt_bridge_init( ALT_BRIDGE_F2S, NULL, NULL);

The output was:

avalon_DDR3_waitrequest became 0 but still no data read ( avalon_DDR3_readdatavalid was always 0, and avalon_DDR3_readdata was always 0).

--- Quote End ---