Cyclone 5, how to read data from Generic Tristate Controller

Hello everybody, this is my first post on this wanderfull forum.

My question is very very stupid... How can i read data from a generic tristate controller?

i have used in my design the altera ciclone 5 board.

i have created a custom component in vhdl that act like a memory, with a 5 bit address line and a 32bit width data linee ecc.

i have done other stuff and.... i have connect my component to the generic tri state contoller using a tristate conduit bridge.

In qsys the base address of the generic tristate controller is 0x0000_0000 and end is 0x0000_001f.... it is possible?

how can i read data from this device ?

I dont need a code, i need an idea. How is mapped the generic tri state controller?

if i need to read the data on my device at address 00001 (in address line), what i need to read from the generic tri state controller?

Help me please :(