Forum Discussion

JWest6's avatar
JWest6
Icon for New Contributor rankNew Contributor
7 years ago

Can't Set Project Name in NIOS-II Hardware Debug Configuration

Hello All, When setting up the debug configuration for a NIOS-II project (compiles file, project has a name...) - I can't make the Project Name drop down box on the debug configuration fill with any...
JWest6's avatar
JWest6
Icon for New Contributor rankNew Contributor
7 years ago

Quartus version is 18.1.0.625

I've resolved that problem - was pointing to the wrong directory.

Now - I can seem to get the jtagserver to start. jtagserver --install seemed to work (running as admin) - but jtagserver --start times out.

Running the diag tool for the cyc1000 board:

Arrow USB Programmer2 Diagnostic Program V1.1

Reading version info.

- Operating system version number is 10.0.17763.

- Quartus version is 18.1.0.625.

Searching programmer hardware.

- Arrow USB Programmer2 AR2E3I3D found.

- Successful.

Reading registry entries for programmer DLL.

- Successful. TCK frequency is 20.000.000 Hz.

Searching programmer DLL.

- Successful. Programmer DLL installed properly.

Checking Altera JTAG server service.

- JTAG Server is installed but not running.

- Error. Wait timed out after sending start request.

Reading registry entries for FTDI driver configuration settings.

- Successful. FTDI driver configuration settings are OK.

Total errors: 1

Hit any key to exit program.

Any clues on this?

Thanks,

John W.