<Board Update Portal based on Nios II Processor with EPCQ> example....

Hi,

--- Quote Start ---

For example, it can be used as a buffer for Ethernet communications, to store Ethernet IPs, to write or read other data, etc.

--- Quote End ---

If the FPGA configuration data does not fill up the entire EPCS/EPCQ device, any left-over space can be used for general-purpose data and system startup code.

--- Quote Start ---

Looking at Qsys, it appears that the data output from the EPCQ controller is not set up

--- Quote End ---

You can use "legacy EPCS/EPCQ Serial Flash Controller" IP Core or Alter ASMI parallel Ip.

Refer below links.Page 165 & 167:https://www.altera.com/en_us/pdfs/literature/ug/ug_embedded_ip.pdf

https://www.altera.com/en_us/pdfs/literature/ug/ug_altasmi_parallel.pdf

https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/ug/ug-asmi2.pdf

For Remote configuration over Ethernet with Nios II refer https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/an/an429.pdf

Let me know if this has helped resolve the issue you are facing or if you need any further assistance.

Best Regards,

Anand Raj Shankar

(This message was posted on behalf of Intel Corporation)