Forum Discussion
RWeiz
New Contributor
New Contributor想要NIOS 硬體跟軟體 燒死再FPGA裡面 到最後一步的時候，出現了ERROR。
Error: No EPCS layout data - looking for section [EPCS-9D6017] Error: Unable to use EPCS device Error: Error code: 8 for command: nios2-flash-programmer "D:/ANSER_Proj/Altera_FPGA/TIJ_Engine_...
Ahmed_H_Intel1
Frequent Contributor
Frequent ContributorHi Ren,
Here is the translation of your comment (My JIC can be burned successfully, because the device will not be connected to the computer afterwards, and the C program must be burned to the FPGA.)
Do you mean that the error is gone? if not please explain more.
Regards,
