Forum Discussion

Occasional Contributor

3 years ago

Using IP as .qxp file

Hello, I have an old desgin implemented on a Cyclone III FPGA. This design uses a 3rd party IP in the form of an .qxp file. I want to migrate the design to an Arria V FPGA. Can I use the same .q...

RichardT_altera

Super Contributor

3 years ago

As mentioned in the KDB:

https://www.intel.com/content/www/us/en/support/programmable/articles/000075849.html

As the recipient of a .qxp file, you will need to ensure that your project targets the same device (or at least the same device family if the .qxp file does not include placement information), as specified by the sender.

So you will need to request the IP vendor to re-synthesize it as it is a different device family.

Forum Discussion

Using IP as .qxp file

Recent Discussions

PCIe Enumeration Failure for CXL IP

Can't generate F-Tile Ethernet Hard IP Design Example

Agilex 7 slew rate reconfiguration

Constraints not being picked for DCFIFO

Cyclone 10 GX IBIS-AMI models