Forum Discussion

SKon1's avatar
SKon1
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

TSE - purpose of "rx_recovclkout"

Purpose of "rx_recovclkout" Hello, I'm using the TSE IP implemented on an Arria V GX FPGA to communicate with an external MODEM over SGMII. My design is sending data to the IP synchronous to "t...
Deshi_Intel's avatar
Deshi_Intel
Icon for Regular Contributor rankRegular Contributor
6 years ago

Hi,

"rx_recovclkout" signal is recovery clock from SERDES PMA block.

For TSE, this signal is not commonly used.

One of the used case for this signal is like for "Synchronous Ethernet" application that required to sync up the recover clock from SERDES channel to external SyncE PLL on the board.

Thanks.

Regards,

dlim

  • Deshi_Intel's avatar
    Deshi_Intel
    Icon for Regular Contributor rankRegular Contributor
    6 years ago

    HI,

    I hope I had explained on the clock usage to you.

    For now, I am setting this case to closure.

    Feel free to post new forum thread for future enquiry.

    Thanks.

    Regards,

    dlim