Serial communication with HPS-UART using QSYS

Hi,

welcome to Intel community & I would like to suggest you , please first go through the related documents available on Intel website like Cyclone V HPS reference manual, Golden Hardware Reference Design (GHRD), training, old thread related to HPS in community etc. since you have started learning recently.

For Cyclone V with HPS refer the below application note,

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an706.pdf

https://www.intel.com/content/www/us/en/programmable/support/support-resources/design-examples/soc/exm-hps-fpga-interface.html

https://www.intel.com/content/www/us/en/programmable/documentation/sfo1410143707420.html#sfo1410067621113

HPS related threads & training,

https://forums.intel.com/s/topic/0TO0P000000MWjkWAG/hps?language=en_US

https://forums.intel.com/s/question/0D50P00003yySNhSAM/route-hps-uart-pins-to-fpga-pins-de0-nano-soc?language=en_US

https://www.intel.com/content/www/us/en/programmable/support/training/catalog.html

when you will start the actual project, please open new thread for each & every specific issue.

Regards,

Vicky