nios 2 is not working after adding the ethernet files

Question

hi

i am using nios 2 for ethernet verification. when i build an hardware platform with nios for just hello world its working fine. but when i add the ethernet ip's then i am not able to download the elf into the custom board.i am using arria 10 fpga

ahmed_h_intel1 · Answer

Hi,
     Please check the following examples for Arria 10 FPGA Dev-kit using the ethernet IPs:
1- https://fpgacloud.intel.com/devstore/platform/16.0.0/Standard/arria-10-low-latency-ethernet-10g-mac-and-xaui-phy-reference-design/
2- https://fpgacloud.intel.com/devstore/platform/16.0.2/Standard/arria-10-scalable-10g-ethernet-macnative-phy-with-ieee1588v2-design/
3- https://fpgacloud.intel.com/devstore/platform/16.0.0/Standard/arria-10-soc-scalable-multispeed-10m-10g-ethernet-design/

for more examples please visit the design store :
https://fpgacloud.intel.com/devstore/platform/?acds_version=16.0&amp;ip_core=Ethernet
Regards,

Forum Discussion

nios 2 is not working after adding the ethernet files

1 Reply

Recent Discussions

What if I did wrong recharge in Jio?

Can we get a refund for a wrong recharge in Jio?

How do I complain about my RBL credit card?

Constraints not being picked for DCFIFO

F-Tile xcvr placement on DK-DEV-AGF023FA