Hello friends! I'm trying to transmit data through jesd204b IP and create an example for it. My question: why is it not started? all n_resets are at null. How can I start it?

Hie, My apologies for the delayed first response for this forum case; I had a few JESD questions,and missed updating this one. To ensure your design is configured and connected correctly, please use the Quartus generated Design Example. You may refer to the user guide below for Quick Start on generating an Example Design. https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-dex-a10-jesd204b.pdf After that please, make sure install the Arria 10 Development Kit Installer Package. Please select the correct reference clock and system clock frequencies using the clock control GUI. This step is also covered in the user guide. You can perform the Test to check the operation of JESD IP using the tcl included in the Example Design. The steps are also covered in the user guide. Please check if this enables your design to work. Regards, Nathan