Forum Discussion
ANi
New Contributor
New ContributorHDMI RX IP question
used HDMI Intel ® FPGA IP and Rx IP. The interface part has a signal: (in -5V -power). I checked the HDMI 2.0B specification requires the core to respond to the presence of the 5V input from the co...
Deshi_Intel
Regular Contributor
Regular Contributorhi,
As per my understanding, 5V signal is used together with the HPD signals as explained in below HDMI board design guideline doc
- https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an837.pdf
- You can refer to the doc for further detail
As this is part of HDMI spec requirement, I don't think we can ignore this signal
Thanks.
Regards,
dlim
