Forum Discussion

New Contributor

5 years ago

Error (14566): The Fitter cannot place 2 periphery component(s) due to conflicts...

Hi,guys! Today I am building a DDR4 project using the Arria10 EMIF Interface. When I configured the project for DDR4-2400R LRDIMM x72, I generated an example that contains two traffic generators, t...

Rashmi1

Occasional Contributor

5 years ago

Hello,

can you please review the KDB :

https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/component/2017/error--14566---the-fitter-cannot-place-1-periphery-component-s--.html

Let me know, if the work around resolves the issue.

Thanks

Forum Discussion

Error (14566): The Fitter cannot place 2 periphery component(s) due to conflicts...

Recent Discussions

Cyclone-V SCFIFO with M10K/MLAB memory - adding ECC

Agilex3/5 GTS Hard Ethernet IP 10G example design pin loc and io std wanted

Agilex 7 slew rate reconfiguration

Agilex-7 AXI MCDMA for PCIe hang

Constraints not being picked for DCFIFO