Forum Discussion

Длаза's avatar
Длаза
Icon for New Contributor rankNew Contributor
5 years ago

Error (14566): The Fitter cannot place 2 periphery component(s) due to conflicts...

Hi,guys! Today I am building a DDR4 project using the Arria10 EMIF Interface. When I configured the project for DDR4-2400R LRDIMM x72, I generated an example that contains two traffic generators, t...
sstrell's avatar
sstrell
Icon for Super Contributor rankSuper Contributor
5 years ago

The easiest answer is that probably the IP parameter editor was not set up correctly. Can you share your EMIF parameter editor settings that led to the generation of this example design?

#iwork4intel

  • Длаза's avatar
    Длаза
    Icon for New Contributor rankNew Contributor
    5 years ago

    Yes.

    These are the settings.