Do you have any examples (in VHDL) of reading and writing to the User Flash on a Max 10 ? I am not using a NIOS processor and wish to access directly from VHDL ?

Question

ahmed_h_intel1 · Answer

Hi,

Yes, there are some examples do this without having NIOS II. Please check the examples below:

https://fpgacloud.intel.com/devstore/platform/17.1.0/Standard/max-10-user-flash-memory-write-operation/

https://fpgacloud.intel.com/devstore/platform/17.1.0/Standard/max10-user-flash-memory-data-incrementing-burst-read/

https://fpgacloud.intel.com/devstore/platform/14.0.2/Standard/putting-altera-max-series-in-hibernation-using-user-flash-memory-an547/

Regards,

pthom23 · Answer

As per all of your examples, these are in verilog - this is absolutely no help for those of use that do not know verilog - which I why specifically asked if you have any examples in VHDL..

ahmed_h_intel1 · Answer

Unfortunately, there isn't a VHDL example to read/write a user flash on MAX 10. But you can open the platform designer and regenerate the Qsys file in VHDL instead of Verilog. Please make sure to review the inclusion of this file into the top level.

Best regards,

Forum Discussion

Do you have any examples (in VHDL) of reading and writing to the User Flash on a Max 10 ? I am not using a NIOS processor and wish to access directly from VHDL ?

3 Replies

Recent Discussions

AGILEX 7 Series I/M – CXL Type 3 IP Validation with Granite Rapids

Regarding MIPI CSI 2 TX

Cyclone 10GX PCIe / Raspberry Pi

Constraints not being picked for DCFIFO

Agilex-7 AXI MCDMA for PCIe hang