Forum Discussion

New Contributor

5 years ago

Current demand of Max 10 JTAG pins.

Hi, I’m trying to locate literature or details regarding the current demand on the JTAG pins for a Max 10 device. Can the JTAG pins be considered in the same bracket as the general I/O requirements?...

EngWei_O_Intel

Frequent Contributor

5 years ago

Hi Bryn

You can refer to Section "Configuration/JTAG Pins" in the doc below for the JTAG pin connection requirement:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/dp/max-10/PCG-01018.pdf

More information can be found in Chap2.1.1 of the doc below:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/max-10/ug_m10_config.pdf

Thanks.

Eng Wei

EngWei_O_Intel

Frequent Contributor

5 years ago

Hi Bryn

We do not receive any response from you to the previous reply that we have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.

Eng Wei

Forum Discussion

Current demand of Max 10 JTAG pins.

Recent Discussions

Can't generate F-Tile Ethernet Hard IP Design Example

MAX10 TSE reference design

Accessing registers in the PCIE IP beyond MCDMA using system console

Constraints not being picked for DCFIFO

Cyclone IV GX project failed migration from 20.1 to 23.1std