Forum Discussion
NYao
New Contributor
New ContributorCan HDMI2.1 be implemented using Arria 10 -3 grade FPGA?
Dear, I know we have HDMI2.1 demo using A10 development kit, can i using this IP on -3 grade devices? like 10AX027H4F34I3G?
Hi, It is recommended to use Arria 10 FPGA device with speed grade 2 or faster. You might facing timing issue if you use Speed grade -3
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_hdmi.pdf#page=15
BoonT_Intel
Frequent Contributor
Frequent Contributorthis device speed grade is -2. So it is good to go.
NYaoNew Contributor
New ContributorDear，
From HDMI UG below，
it recommend -1 for HDMI2.1 and -2，-1 for HDMI2.0，but i have implement HDMI2.0 on A10 -3 device successfully. Is there any risk if i use -2LG?
