Can Cyclone10LP boot from Micron MT25Q serial flash?

Question

Hello,
I have a board with Cyclone10LP and MT25Q128 serial flash, extend single output mode, do you have IP core or design sample project for me to have a test?

Thanks,
Xiaojun

nuraiman_m_intel · Answer

Hi,Thank you for contacting intel community.We only provide design example in the link below:https://fpgacloud.intel.com/devstore/platform/?acds_version=any&amp;family=cyclone-10-lpKindly refer to Cyclone 10 LP deice overview and handbook for further information:https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-10/c10lp-51001.pdfhttps://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-10/c10lp-51003.pdfRegards,Aiman

Forum Discussion

Can Cyclone10LP boot from Micron MT25Q serial flash?

1 Reply

Recent Discussions

Cyclone IV GX PCIe Hard IP behaves differently on Intel Core I7 vs Xeon root complexes

mipi csi2 tx, upper limit of video width

LVDS Output of FPGA

avalon MM generator read issue

QPP 26.1 fails to generate PLL IP