Forum Discussion
hsyn
New Contributor
New Contributortroubleshoot for 5CSEBA4U23I7N (cyclone V fpga processor)
Hello, I am trying to troubleshoot a pcb with a 5CSEBA4U23I7N cyclone V fpga processor. The resistance value I measured between 3V3 and GND for the intact pcb is around 380ohm. One of the PC...
cfkd
Occasional Contributor
Occasional ContributorHi
To check whether a pin is broken or not, kindly reference this Q and A:
https://community.intel.com/t5/FPGA-SoC-And-CPLD-Boards-And/Broken-Pins-Determination/td-p/727301
Best regards,
Chee
hsynNew Contributor
New ContributorSince the FPGA is not attached to the PCB, I can not power it and test it.
How can I check the status of I/O pins with a multimeter?
Or with a different method.
