Forum Discussion

Visshnu's avatar
Visshnu
Icon for New Contributor rankNew Contributor
5 years ago

The Fitter cannot place 3 periphery component(s) (1 HSSI_PLD_INTERFACE(s), 2 HSSI_PMA_TX_BUF(s))

Hi, In my design ,I have native phy 10g transceiver which works in duplex mode .when compiled ,it ends up in this error during fitter Error(14566): The Fitter cannot place 3 periphery component(...
Deshi_Intel's avatar
Deshi_Intel
Icon for Regular Contributor rankRegular Contributor
5 years ago

Hi,


I am confused. Are you using duplex or simplex mode ?

  • You mentioned you used duplex mode but then there is Tx and Rx module design ?


Can you share your Quartus design QAR file then I can help you to review your fitter error better ?


Thanks.


Regards,

Deshi


  • Deshi_Intel's avatar
    Deshi_Intel
    Icon for Regular Contributor rankRegular Contributor
    5 years ago

    Attached is fitter error explanation