Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Stratix IV Serial Configuration Device

I am beginning a design that is built around the Stratix IV, and I have been looking at the configuration schemes to determine the best option for us. We have decided that we need to be able to use ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Not that I can recommend this to you but on my Stratix II GX designs that use Active Serial, I've gone ahead and connected it to the FPGA with the I/O voltage set at 1.8V and it's always worked fine.

The datasheet recommends you use a level translator.

Remember of course that you are not required to use Active Serial for remote update. You can do passive serial or passive parallel but you have to have an intelligent external controller to program the FPGA.