Stratix 10 MX HBM2

Question

Hello, does anyone know if the HBM2 interface is connected only to the ARM side or the FPGA side? I'm interested in this device because of the 16GB of memory not the embedded ARM cores and have no intention to use the ARM cores. Would it be simply setting up Qsys? to access the EMIB to the on-chip DDR memories?

Thanks,

Joe

altera_forum · Answer

The HBM2 is not connected to an Arm processor it all. It requires the use of an Arm AMBA 4 AXI interface but does not require an Arm processor.

See these online trainings for details:

https://www.altera.com/support/training/catalog.html?keywords=hbm

Forum Discussion

Stratix 10 MX HBM2

1 Reply

Recent Discussions

USB blaster isuee

USB Blaster conflicts with other FTDI devices result in PC crash

USB Blaster III Pin connection

MAX10 Single end I/O low/high speed bank frequency

Timing Behavior of Remote Update IP After Reset on Cyclone 10 GX (10CX150YF672E5G)