Signal Tap List File in tcl

Question

Hi,

I am able to capture the signaltap with tcl script. I also wanted to create the signal tap list file for an instance after capture.
Is there a way to do this in tcl?

syafieqs · Answer

Hi Sanju,May refer to link below of How to Create SignalTap II List File with console commandhttps://community.intel.com/t5/Intel-Quartus-Prime-Software/How-to-Create-SignalTap-II-List-File-with-console-command/td-p/61799Some reference for scripting with QP Pro User Guidehttps://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-qpp-scripting.pdfThanks,Regards

Forum Discussion

Signal Tap List File in tcl

1 Reply

Recent Discussions

Shift Register Inference on Intel FPGAs – LUT-based Implementation Similar to Xilinx SRL?

LVDS TX/RX Pin Assignment Error in Quartus – Unable to Resolve

Cyclone 10LP 3.3V interface 3.0V VCCIO Bank

MAX10 Soft SERDES set_input_delay constraints

Potential Documentation Error in ES-1057 Errata Doc: "HPS EMAC" Issue Listed for Arria 10 GX/GT