Forum Discussion

BCrowell's avatar
BCrowell
Icon for New Contributor rankNew Contributor
2 years ago

Remote Update of Cyclone 10

In my application I would like to have an application configuration that is normally used on every power cycle and a golden default configuration that is used only when the application config fails t...
Configuration
FakhrulA_altera's avatar
FakhrulA_altera
Icon for Regular Contributor rankRegular Contributor
2 years ago

Hi BCrowell,


Please ignore my earlier comment. I consulted with my senior, who is an expert in RSU, and it turns out you can load the application configuration directly and only resort to loading the factory configuration if error occurs. This is known as "Direct to Application" (DTA). For more detailed information about DTA, please refer to pages 6-7 in the Remote Update Intel® FPGA IP User Guide : https://cdrdv2.intel.com/v1/dl/getContent/794025?fileName=ug_altremote-683695-794025.pdf


Regards,

Fakhrul



  • FvM's avatar
    FvM
    Icon for Super Contributor rankSuper Contributor
    2 years ago
    I see "DTA" mode provided only for Arria 10/Cyclone 10 GX, not Cyclone 10LP.