Forum Discussion

New Contributor

5 years ago

Remote update hex file in UFM MAX10 due to UART

I need to update hex file remotely in MAX10 by help of UART. So can I have an access to on_chip_flash IP NOT using HAL software, but due to hardware composed verilog's module?

YuanLi_S_Intel

Regular Contributor

5 years ago

Hi Johny,

The design example that i was referring is in link below, it involves with NIOS II, QSPI flash:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an741.pdf

Apologize that we dont have the design example to upgrade UFM remotely.

Thank You.

Forum Discussion

Remote update hex file in UFM MAX10 due to UART

Recent Discussions

LTC Connector DE10-Standard FPGA

Issue with configuring EPCQ64A & Cyclone

Agilex5 A5EB013BB23BE4S BSDL

MAX 10 FPGA Programming Failure via JTAG – nSTATUS & CONFIG_DONE as No Connect

ASx4 Interface debug in MSEL=111 (JTAG mode)