Forum Discussion

fpgaSoft's avatar
fpgaSoft
Icon for New Contributor rankNew Contributor
2 years ago

Remote update for Cyclone 10GX

I am writing a bootloader programme using the Intel Remote update IP on a cyclone 10GX. The Remote update block is part of a NIOS II system and is setup using platform designer. The factory image i...
Configuration
NurAiman_M_Intel's avatar
NurAiman_M_Intel
Icon for Super Contributor rankSuper Contributor
2 years ago

Hi,


"However, when in the application image there appears to be no way of telling that the application image is the image running. ie the RU_CONFIGURATION_MODE is 0 not 1 as I expect.

This was set to 1, in the factory image, prior to starting the application image - using Altera's function "altera_remote_update_trigger_reconfig""


-When starting the application image, set the RU_CONFIGURATION_MODE to 1 in the application page. Factory image is 0.

You may refer to the Remote Update IP userguide below page 15.


https://www.intel.com/content/www/us/en/docs/programmable/683695/19-4-19-1-0/remote-update-intel-fpga-ip-user-guide.html


Regards,

Aiman