Forum Discussion

uzumaki's avatar
uzumaki
Icon for New Contributor rankNew Contributor
2 years ago

stratix v dsp fpga board, how to enable aommunication through PCIe edge connector

When I insert the Stratix V DSP dev board through PCIe slot the board powers up but i have no idea how to establish communication between FPGA and HOST PC. I tried the .qsys file of gen 1 and complie...
Configuration
KhaiChein_Y_Intel's avatar
KhaiChein_Y_Intel
Icon for Regular Contributor rankRegular Contributor
2 years ago

Hi uzumaki,


After compiling the design and generating the sof file, you have to program the sof file into the Devkit. Programmer showing "no hardware detected" indicates that the JTAG does not detect the hardware connected to it. Please ensure that you have connect the On-Board USB-Blaster II to the board and power on the board. The On-Board USB Blaster allows the configuration of the FPGA using a USB cable which connects directly between the USB port on the board (J7) and a USB port on a PC running the Quartus Prime software.


You may find the detailed Board Setup steps in https://www.intel.com/content/www/us/en/products/details/fpga/development-kits/stratix/v-gs.html

( Reference Manual and User Guide )


Thanks.

Best regards,

Khai


  • uzumaki's avatar
    uzumaki
    Icon for New Contributor rankNew Contributor
    2 years ago

    Thanks for the reply

    But my question is how to configure board through PCIe edge connector , I have configured using USB Blaster by writing its driver given by intel solutions, but I'm not able to find any driver files for PCIe for linux based system Ubuntu 22.04 LTS.

    If you find any PCIe driver for linux system please let me know