Forum Discussion

Honored Contributor

13 years ago

PS Config using SPI EEPROM

I am working on a project using a Cyclone III device. I have the board setup to use an EPCS4 to configure the FPGA. The EPCS4 is programmed by a byte blaster. The EPCS4 is very expensive. Th...

Altera_Forum

Honored Contributor

13 years ago

Macronix is another manufacturer.

Forum Discussion

PS Config using SPI EEPROM

Recent Discussions

Vcm for the clock input pins of agilex5 E-series FPGA A5ED065BB32AE5SR0

EMIF Pin Assignment for Agilex 7 FPGA I-Series DevKit (DK-DEV-AGI027R1BES)

Timing Slacks inside Altera IP

Part Status request

Agilex 7 DDR4 Reset and ADDR/CMD Clock PCB Implementation Documentation Discrepancy