Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

Pin for EPCS16 are not displayed

Hi @ All, I want to load my Cyclone II FPGA from an EPCS16. In File > Convert Programming File, I generated the programming file. In the programmer, I can see the EPCS16, too, as shown in t...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

Remember, you are programming an image into the EPCS16 (Which is essentially a FLASH device). The image is loaded from the EPCS16 into your Cyclone part at powerup/configuration time.

Why do you need to see pin information about the EPCS16 in the assignment editor? The assignment editor is used to setup pins etc within the target Cyclone device.