Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

Output pin load assignment

Hello, I want to ask about the "output pin load" assignment. Should I set this value as the total capacitance of the whole transmission line and receiver device? Some say that it should be deri...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
18 years ago

There is a doc on Altera's site how to understand / interprete tco - values. An366 I think it was. There is much said about capacitance assignment. For me I am doing worst case design with that in variating these values with extreme settings.