Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorMSEL setup with Cyclone III part
Hi, We are working on a board including a Cyclone III FPGA. The MSEL pin belong to bank 6 which VCCIO in our design is 1.8V. Is it still valid to use a 2.5V voltage with this configuration ? If...
Altera_ForumHonored Contributor
Honored Contributorfrom: http://www.altera.com/literature/hb/cyc3/cyc3_ciii51010.pdf
--- Quote Start --- The MSEL pins are powered by the VCCINT power supply of the bank in which they reside. --- Quote End ---
