Forum Discussion

Occasional Contributor

3 years ago

MAX 10 Remote Update for External flash image

Hello everyone. We are running a custom board with a MAX 10 and a winbond W25Q64JV external flash chip. In Qsys I have Nios2 processor, the Generic Serial Flash interface(driving the winbond ex...

Farabi_Altera

Regular Contributor

3 years ago

Hello,

There is a good documentation on Remote upgrade using NIOS II as RSU controller.

link : https://www.intel.com/content/www/us/en/docs/programmable/683661/current/reference-design-functional-description.html

You can refer to this document to perform the remote upgrade.

regards,

Farabi

Forum Discussion

MAX 10 Remote Update for External flash image

Recent Discussions

MAX 10: Can an ASx1 RBF be written directly to internal CFM via on-chip flash Avalon-MM?

Cyclone V SoC 5CSXC6 Series GXB Utilization and Limitations

JESD204B RX Link Never Achieves CGS at 12.8 Gbps on S10 ES (1SG280LU3F50E3VGS1, Quartus Pro 17.1)

Unable to Generate Valid PAM4 Eye Diagram and BER Measurements on Stratix 10 SI E-Tile Native PHY

Error (209014): CONF_DONE pin failed to go high in device 1.