Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Lost Quartus II project

hi

i am a university student, made servo control board using MAX 3000 device now i have lost my quartus II project (Student Version) because of my harddisk failure now i have only one programmed EPM3128ATC100 device , may i recover my project filed from this device.

14 Replies

Show More
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    17 years ago

    i am using 3rd party BYTE BLASTER hardware for programming

    regarding this examine feature in my QUARTUSII programmer i am unable to check on examine CheckBox
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    17 years ago

    --- Quote Start ---

    i am using 3rd party BYTE BLASTER hardware for programming

    regarding this examine feature in my QUARTUSII programmer i am unable to check on examine CheckBox

    --- Quote End ---

    Hi,

    which programming mode are using ? Did you use a Altera Web edition ?
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    17 years ago

    --- Quote Start ---

    yes its an altera web edition

    --- Quote End ---

    Did you use the "JTAG" programming mode ? Unfortunately I have not the Quartus 8.0 Web edition available, but in the 8.1 Version I'm able to switch the examine feature on.