Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

JTAG Programing Cyclone III device

Hello, I`m new in developing boards with Altera, thus i tried to develop the simplest design: just Cyclone III, and a few leds. I`m going to program it with Usb blaster via JTAG, but when ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

dedannan is using E144 device in the schematic, which doesn't have MSEL3. So I think the problem is caused by something else. It is better to show the actual error message in the post...

One thing might need to be noticed: nStatus and CONF_DONE need to be connected to Vccio of the bank they belong to. I see all the Vccios are either 3.3 or 1.2, not 2.5. Could this be a problem?